Hi All,

I am new to the Aussie Magna Club and forums generally.
I was hoping someone could help me with some practical advice on how to remove my (broken) cd payer from the dash of my TL ES Wagon. Any photos woudl be super.

Thanks in advance,
Adam

Welcome to the club.

This should be some help.

http://www.aussiemagna.com/forums/showthread.php?t=31351&highlight=centre+console+removal

With Pics.

Easy Peasy, Ease (http://i228.photobucket.com/albums/ee217/SH00T/IMG_0224.jpg) out the gear surround ( includes P/W controls and Cup holders), Prying (http://i228.photobucket.com/albums/ee217/SH00T/IMG_0225.jpg) upwards all around and it comes off, the very front is the only bit that doesnt unclip. that slots in at the front, Disconnect (http://i228.photobucket.com/albums/ee217/SH00T/IMG_0226.jpg) the Power window connection plug,
Apply hand brake, Chock if not on level ground, Place car in neutral and pull surround sliding to the rear of the car.
This is the hardest bit, removing the compartment above where the cup holders were. With the lid open place palms facing upwards Gripping (http://i228.photobucket.com/albums/ee217/SH00T/IMG_0227.jpg) as well as you can manage (http://i228.photobucket.com/albums/ee217/SH00T/IMG_0228.jpg) with both hands ( dont grab the door) and pull to rear of the car. This exposes (http://i228.photobucket.com/albums/ee217/SH00T/IMG_0229.jpg) two screws to remove and the last panel prys (http://i228.photobucket.com/albums/ee217/SH00T/IMG_0231.jpg) off. Disconnect (http://i228.photobucket.com/albums/ee217/SH00T/IMG_0232.jpg) aircon controls, hazard lights and air temp sensor. And the bracket holding in the stereo is right before you, take (http://i228.photobucket.com/albums/ee217/SH00T/IMG_0232-1.jpg) care with the top screws, they require a metal clip to secure themselves and are like ly to jump off when reattaching. Tape them in place.....


From Here.
http://www.aussiemagna.com//forums/showthread.php?t=52841 Stickied in the audio section

Depending on where you, I'd be happy to help, I'm in springwood.

I would recommend Aerpro H/U to Car Adaptor plugs.
http://www.ryda.com.au/Aerpro-Mitsubishi-Wiring-Harness-Late-Models-p/ap7011.htm You could solder that to the Plug on your new H/U
I would put a better earth on though.
And depending on brand. The Aerial power or Amp power needs to go to your Aerial.

Thanks heaps. Your explanation and photos are excellent.
Regards,
Adam Mann