Hi all.
Just had my Tf V6 5 speed Banksia hand brake looked at today, found i needed a roll pin for the RH brake mechanism. (they always fall out)
Thats now replaced..... but when you release the hand brake to drive off, it kinda still holds position on hill, but you can feel it disengage moments later. I have tried in reverse too.
(but cables under center console are slack)
:roflwtf:

So has any one else had similar problems or do i need to adjust it myself.
From what i know, you adjust the slack cables from inside?

Could it be something simple as a spring not returning or catching cables somewhere?

Quite annoyed.

Cheers

may need to be readjusted on the rear hubs

Thanks Mate.

Took it to a brake fella today (should of gone there 1st).
Said i need a new screw adjuster cause its all gone c**k eyed.
$27 complete assy + labour.