hi guys. i was just wondering if people with 3l 3rd gen could send me a pic from under there car of their extractors? mine seem to be the lowest part on my car and there getting damaged very badly? is anyone elses the same as this? ive noticed loss in power since the pipes have been banged in. can i get them repaired or would i have to buy new ones ?

http://img249.imageshack.us/img249/9691/pacemakers7.jpg

http://img14.imageshack.us/img14/5118/pacemakers8.jpg

http://img14.imageshack.us/img14/8118/pacemakers.jpg

If you extractors hang any lower than these I suggest getting your engine mounts checked.

Remember a 3.0 has a shorter deck height than a 3.5 so the extractors hang a fair bit lower on a 3l. I couldn't tell you the exact difference though... Maybe 1/2 and inch?

The pictures above are from Eagleock18's 3.0L TF.

The pictures above are from Eagleock18's 3.0L TF.

Oh... lol

They are a bit awkward to see how low they hang in those pics. Do you have any showing the actual ground clearance front on?

No but if you take into account the height they are compared to the crossmember then you should get a reasonable idea. basically the lowest part of the flange on the front extractor is the same height as the crossmember at it's lowest point.

Remember a 3.0 has a shorter deck height than a 3.5 so the extractors hang a fair bit lower on a 3l. I couldn't tell you the exact difference though... Maybe 1/2 and inch?

18mm comes to mind.

think the front 3 of mine hang bit further. only abit tho ill take a pic tomorrow