Ok i have searched, but havent found anything.

On standard headlights how i remove the clips holding the globes in? I have been out there trying for 20 minutes.

Also, H4 will fit?

On the drivers side - looking into the bonnet, the clip on the bottom right (looking at it) of the globes comes off, but something on the left is keeping it held in there.

Okay, i worked it out....but when i took the clip off, the whole clip device came off - not sure if this is meant to happen. Now when i put it back on, the top of the globe isnt held in properly, it rattles around. And how the hell do you get the clip off the connection to the globe on the passenger side. Its sooooo tight in there. Thats what she said.

get a small mirror then u can see how it clips out/in iirc push towards the front of the car and down/up.

get a small mirror then u can see how it clips out/in iirc push towards the front of the car and down/up.

Ok cheers mate ill give it a go tomorrow. Im pissed though - i think i may have bent the drivers side clip and the globe is just rattling a bit. ARGH!

On the passenger side, I remove the top half of the battery cover and the rubber water seal thing around the back of the headlight.

Drivers side, found my fingers weren't nimble enough so pulled out the washer bottle.

On the passenger side, I remove the top half of the battery cover and the rubber water seal thing around the back of the headlight.

Drivers side, found my fingers weren't nimble enough so pulled out the washer bottle.

Removed the washer bottle that side wasnt too bad,

Removed the top half of the battery cover, but its soooo tight in there with the coolant dipstick. I just couldnt get that clip off!