hi all, recently converted a tr 4cyl to v6, engine harness, computer and all. engine cranks but not getting any fuel or injector pulse and fuel pump isn't even running. this is a love job and just want it out of my hair, any advice
would be greatly appreciated

any power to the fuel pump
or fuel relay

Sounds like either the ECU you have used may be faulty OR you have not completed power.

You will need to do a pin out on the ECU to ensure that all pins that need power have them, and if all good then check that the ECU is giving the relay a signal to fire up

If you are not getting pulse either, could be ig issue or also could be that there is a disconnect somewhere thus the pulse from dist etc is not getting through

nothing to the fuel pump, cant even find the relay

thanks for that ill have to do a bit more checking, might be time for an auto lec