hey everyone,
I finally got the head installed on my car on Monday, but I had to undo the plenum from the inlet manifold as I pushed the support to far back, and couldn't oull it back cause it was catching. My question is, do I need to put anything on the plenum gasket, example Aviation 3??

Thanks
Michael

hey everyone,
I finally got the head installed on my car on Monday, but I had to undo the plenum from the inlet manifold as I pushed the support to far back, and couldn't oull it back cause it was catching. My question is, do I need to put anything on the plenum gasket, example Aviation 3??

Thanks
Michael

hi Michael
you could smear a light film of silicon over the gasket on both sides as long as the gasket has not been bent this will help it seal again and by only putting a light film on it , it will be able to come undone at an other time if needed
cheers liam