hi

what power window regulators can be custom made to fit the tr/ts magnas,

may put in power windows and read somewhere of fabricating stuff/brackets

cant you just get them out of a verada? otherwise im pretty sure the rear ones are them same from first gen. not sure about front tho.

heres some links i found:

http://www.aussiemagna.com/forums/showthread.php?t=50589&page=3

and there is one mention on the faq section on the stickys

enjoy

is 15a wire going to be enough for a power window motor to wind a window up/down or would a higher amperage be needed

what size wire is needed

well the supply is a 30 amp fusable link in the engine compartment relay / fuse box. so supply has to be equally to that.

and depends what you mean by 15 amp wire. ide say as long as you used something decent like thick figure 8 wire as the other post says you will be right. just match it to the thickness of the wire on the switches ect. but i cant see it drawing much more than 15 amps each motor if its only a 30 amp supply.