View Full Version : engine and gearbox
car10002
26-06-2011, 02:20 PM
hi
what engines fit in a 93/94 magna without inspection
what other transmissions bolt to a magna 3l engine if there is others that bolt in
the same engine that come out and auto or manual trans I guess.
I think the GTO/3000GT setups will bolt into a 2nd gen with a lot of fiddling around with electrical work but good luck with passing inspections.
car10002
26-06-2011, 03:46 PM
what other transmissions fit
what other model engines and traansmissions fit with no inspections
MadMax
26-06-2011, 04:03 PM
Whatever the car came with originally from the factory, 2.6L 4 cylinder or 3.0 L 6 cylinder, with auto or manual gearbox. Anything else would need engineer's certificate, lots of paper work and lots of $100 notes.
car10002
26-06-2011, 08:51 PM
just intrested to know if a te 3.0 engine or transmission would go in a tr/ts
will a te ecu/inlet manifold or both run a tr/ts v6 engine and will a te 3.0 manifold fit a tr/ts engine
Sparky
26-06-2011, 09:05 PM
just intrested to know if a te 3.0 engine or transmission would go in a tr/ts
will a te ecu/inlet manifold or both run a tr/ts v6 engine and will a te 3.0 manifold fit a tr/ts engine
One word "nope" :(
MadMax
26-06-2011, 09:34 PM
just intrested to know if a te 3.0 engine or transmission would go in a tr/ts
will a te ecu/inlet manifold or both run a tr/ts v6 engine and will a te 3.0 manifold fit a tr/ts engine
Lift the bonnet on both and you will see why.
Sparky's "nope" is very understated.
car10002
26-06-2011, 09:55 PM
will a te 3.0l inlet manifold fit a tr/ts 3.0l engine, will a te 3.0l ecu run a tr/ts 3.0l ecu if its custom wired
also will a transmission from a te bolt to a tr/ts model engine if both engines are the same capacity with some work
MadMax
26-06-2011, 10:04 PM
Read above posts.
-lynel-
27-06-2011, 03:26 AM
to the OP if you did a search you would know that the tr/ts engine and gearbox combo is orientated differently to the te onwards. everything is around the wrong way to work on a tr/ts. By inspection do you mean engineers cert? because they arent that expensive and you could do a gto swap very easily and have it regsiterd. they are the saeme engine code, so i dont even think they need a cert, they just need to change the engine number on the rego. provided the engine is the same year or newer then your car. you could go turbo manual this way but then you might run into dframas with rego
Powered by vBulletin™ Version 4.0.3 Copyright © 2016 vBulletin Solutions, Inc. All rights reserved.