im installing central locking in my TM and i have found a pic from floaters manga but it was only the rear doors im stuck on the front doors because of how its arranged, so any one who has done it would u be able to show how its done.

Hi shaun, I am about to go through the same thing on my sons TP wagon ,I am just waiting for the kit to arrive,I have found this link with some pictures and diagrams which is quite helpful http://www.rapidelectronics.com.au/knowledge/questions/6/Installing+Rapid+Electronics+Central+Locking
jayone

hi shaun, i mounted the central locking unit just below the door latch. from memory i had to drill holes and then screwed straight in. the metal rod connects straight to the rod in the door lock. hope this helps. i don't have any pics or diagrams.

helps a bit ill figure it out now i know u had to drill holes. thanks

My Kit has arrived now so I will be starting it tomorrow,apparently it is advisable to put loctite on all actuator mounting screws to avoid loosening through vibration.

This thread from Cheyenne offers a lot of specific help http://www.aussiemagna.com/forums/showthread.php?t=88538

the factory system mounts under the door lock on the side of the door. just be careful to keep it clear of the window winder mechanism. mine use to jam because i used 2nd gen actuators which are much better then first.

good luck!
regards jay

yeay i got the front sorted and the back doors are simple.

Shaun Mate, where did you mount the control box??

up next to my alarm system behind the fuse panle in the dash

Thanks!