Okay.. So where do these get wired into?

I have had a set for a while and havent bothered wiring them in.

Where do they wire into and where do I run the wiring..?

SuFz :ninja:

To the rear tail lights to the park lamp circuit :)

Double post lol

Dave.. How's your weekend looking..?

it's actually not a hard job.. all you need to do is follow the wires from the top light (which should be the rear parking light when the headlamps are on), splice the cable open, add your wiring and solder then use some heat shrink (... or a lot of electrical tape :P) to seal it all up. BTW you won't need to drill holes in to your panels, just feed the wiring between the tail light holes and bumpers to your side markers

now make sure it's the parking lights otherwise your side markers will light up every time you brake lol

I'll give it a crack tonight.. see how it goes!

SuFz

Please tell me where you got them, I'd love to get them! So much better than trying to DIY it.

I got them from the US.. AUD$25 Incl. Postage.

SuFz :ninja:

my weekend not busy lol and next week is not busy either what your point lol

I got them from the US.. AUD$25 Incl. Postage.

SuFz :ninja:

lol Derp... Why didn't I think to check eBay. :(

Thank you! Found some already. :)

lol Derp... Why didn't I think to check eBay. :(

Thank you! Found some already. :)

A set just went last week for almost $90 inc the rip off $37 postage. I was bidding until it got stupid.