hi there i have a kj s1 verada main loom that goes behind the dash loom, now l brought this from the wreckers and somebody cut the loom on me.

l have joined the wires back up and are left with one wire beening a green wire with orange line but dont know where or whats it for could someone help me thanks,

here is the pics
http://i1155.photobucket.com/albums/p546/W_King/junk/wires.jpg
http://i1155.photobucket.com/albums/p546/W_King/junk/wire.jpg
http://i1155.photobucket.com/albums/p546/W_King/junk/P2200001.jpg
http://i1155.photobucket.com/albums/p546/W_King/junk/P2200003.jpg
http://i1155.photobucket.com/albums/p546/W_King/junk/P2200002.jpg

What part of the loom was cut? Got any pics? Green wire with a orange line, is most probebly cabin illumination (negative for the interior lights) it runs off the BEM.

updated with pic

anybody??????

Bell out the wire to see where it goes. Take a photo of the plug form behind where that wire enters and then I can tell you where that wire goes.

ok will do

Awww man... I'm naked and eatting dinner atm.. I'll let you know soonish.

haha to much info when you ready

Ok that plugs into the relay box under the driver's kick pannel. My car doesn't have that wire so I'll have a gander at the workshop manual and let you know.

Plug name is = "B-76"

This wire does not exist.

I honestly cannot find this wire in the circuit diagrams in the TH,TJ or TL/W circuit diagrams. The wire runs to pin 8 on plug B-76. I checked the other wires going to the plug to confirm the plug is B-76, the colors match up to what's in your plug.

I'll post some screen dumps in a tick.

Personally I think you should tape it up, but if it is something important then you're rooted. Does the cut in this wire match a cut in another part of the loom where you've joined the wires else where?

IF I get a chance in teh next day or 2 I will check over one of the several series 1 looms I have in the workshop, am fairly flat out but may be able to get a chance later in the week

http://img41.imageshack.us/img41/2381/confusedns.png

B-90 is not listed as a plug in the configuration diagrams...

http://img692.imageshack.us/img692/2318/wtfxdb.png

I'm still naked :D

the loom is from kj s1 and thats wear is was cut have joined all the wires and this was left, someone cut it and took the plugs and a peace of the climate control unit and this is what i was left with it got me f$$ked

ok if thats wear it going why would the wire be near the radio?????

Have you had a chance to test fit the loom and see if everything works? Maybe its something to do with an aftermarket alarm the vr-x donor car had? Obviously it'd be quite a sophisticated alarm system to be integrated into the loom but possible I suppose.

Mate, when you come over to pick up that steering wheel, why dont you grab one of these harness I have here to look at, you may be able to work it out.

I am sure I have seen that wire before and done something with it, just has me beat as to what it was for without looking at the actual harness

ok will do that mal thanks just pm you my details

I have rebuilt one of these looms before and that wire is necessary, I will look tonight.

Mike

Plug B-76 is usually the plug controlling the Verada extras like lights, climate, etc.

There is an extra wire with a 20 amp fuse living next the the JB that could be that color.

Mike