Hey All

Recently purchased a Series 2 DB Platinum Edition, with SVI LPG!

I cannot for the life of me get the reversing sensors to work.

I've checked the piezo buzzer and that works fine...

Any suggestions?

Meh, who cares, drive forward, the380's are much quicker that way lol
Great to see another svi equipped 380....
Welcome to the madhouse.....BTW
Someone should help with the sensors too...
Goodluck....

Checked all your fuses?

Do your reversing lights work?

Checked all your fuses?

Do your reversing lights work?

Thanks, Yes and Yes...

Meh, who cares, drive forward, the380's are much quicker that way lol
Great to see another svi equipped 380....
Welcome to the madhouse.....BTW
Someone should help with the sensors too...
Goodluck....

Yes, I know, but I like to reverse up the driveway; this way in the morning I only need to select the fast gear!

Thanks for the warm welcome!

I like to reverse it up my driveway...this way I only need to make one selection, "D" at 6 in the morning...easier on the still waking brain!



Thanks for the

Checked all your fuses?

Do your reversing lights work?

Do u get the initial "beep - beep" when you select reverse? - If so power to unit is OK, and either sensors or unit is problem.

I vaguely recall another post/thread somewhere suggesting they are very sesitive to dirty connections at the unit - plug and unlpug a few times to try.

Unit has off low hi settings - it is on I guess?

Do you have the additional owners manual for the system - 12 pages - if not I can scan and pm to you

T

No was not getting the initial beep when selecting reverse.

I braved the Adelaide heat and had a look. After probing with my multi meter I found the control unit was not at all grounded.

I looked at the loom at the left hand tail light and the earth / negative lead was plugged into a grey wired plug. I noticed a similar black one and plugged it in to be greeted by a blaring piezo.

It is all good now.

Thanks all for the replys.

@telpat16 - yeah, if you've the manual, for sure. It is the only manual I've missing.

Cheers all.

No was not getting the initial beep when selecting reverse.


@telpat16 - yeah, if you've the manual, for sure. It is the only manual I've missing.

Cheers all.


On its way to your gmail address

T