Hi guys, I am planning to feed a few sires into the front doors of my TL to make indicator works on the door mirrors and make it folds according to the ignition key. What is the easiest way to feed the wires into doors? How hard is it? If it's not too bad, I might think about install two sub-woofers into the rear passenger doors. Any advice will kindly appreciated. Kind Regards.

You can follow the standard grommit in where the loom goes but it is a PITA of a thing to do though!

Haven't tried on the magna but people that have say it is. Otherwise just bypass the grommit and have the wires exposed

You can follow the standard grommit in where the loom goes but it is a PITA of a thing to do though!

Yeah do this, its how i did the LED lighting in my doors. Its true, it is a b**ch to do, but it looks legit, and you don't have to worry about exposed wires. Haven't had a problem since i did it.

If you want to do it properly. Go to the wreckers and pick some wires out of a door loom on both sides of the loom. There are plenty of blank pins on the looms.

Add these pins into your existing plugs for factory-like fitment.

If you want to do it properly. Go to the wreckers and pick some wires out of a door loom on both sides of the loom. There are plenty of blank pins on the looms.

Add these pins into your existing plugs for factory-like fitment.


This....

And to pull the wires through the rubber. Unclip the plug and then try a coat hanger with the end bent back on itself so you dont cut the rubber or any wires.

Thank you guys! very informative indeed. I will let you guys updated when they are on!