My presure line went from the joiner, so im getting a aftermarket one made and i know the conector on the pump side, but am whanting to know excatly what 5/16" conector type is on the rack.
Thanks

the rack uses a metal pipe and orings at both in and out pipes at the rack
a guess it needed a 17 MM pipe spanner

the pressure line has to be the same as a genuine size
that goes onto the pump

I just get one from the wreckers
when I made inquires about an after market ... it was way too expensive

Yer i need the thred type, im getting enzed to make me one and its 50 bucks cheaper and stronger than factory

i was going to get one made but doug talked me out of it and he was right. find one that dosnt leak, put it in and it wont leak anymore lol

i was going to get one made but doug talked me out of it and he was right. find one that dosnt leak, put it in and it wont leak anymore lol
lol talked you out of it
told you i had one you could have

got one made using the exsisting fitting on the rack and they had the fittings for the pump. its got less 90deg bends and runs a bit lower through the engine bay