Hi Guys can i transfer sedan looms into a wagon without too much hassle? or do i have to get wagon looms especially for the rear wiper setup in the wagons?

Rear looms are specific to the Wagons, are totally different. From the dash forward they are the same as the sedans except in a few of the L and W series.

thanks mal for that confirmation

Ok im putting in sedan looms from a TH Sports along with the engine and trans would my late model TF rear looms be compatiable or do i need to buy the specific looms from a th wagon?

The TH front looms will be fine, you will need to repin one of the the plugs on the LHS front where it connects in the front foot well.

In a TF I did here for another member I used KJ front, engine, dash and cross over loom with the TF rear looms on both sides, after the plug was re pinned all was good.

Keep in mind the TF already had SRS as well as ABS as was an Altera LS so everything needed was there.

Am curious as to why you want to use TH Sports looms though as you are only gaining the ability to use the TJ ECU, if that is all you need and you dont have cruise, just use the TH or J engine harness with an unlocked ECU or plug the TJ ECU into the TF one and remove the check engine light globe, have done this myself initially in my old TF and worked fine

I am removing and selling the evo motor out of my wagon so I'll need to remove all looms as I'm picking up a TH sports so I can changeover parts.

Also my tf is a exec so it has no cruise, abs or power windows I'm hoping I can get away without putting the abs in but I'll suss it all out once it is apart

Just updating this i picked up a KJ GTV wreck cheap recently and ill be putting most if not all looms in including the 5 speed auto with TCL in im just wondering do i need the series 2 T/KJ wagon looms for this to work or can i repin some wires in the TF wagon loom?