Hey chaps,

Just curious as I'm looking at Ralliart Magnas, does anyone know why some of them have dual exhausts and some don't? Most of the ones I've seen are single exhaust but then I've seen a couple like this:

http://carphotos.cardomain.com/ride_images/3/2901/4201/32252100007_large.jpg

Also, would the C pillar lights, Verada map light unit, and lit sunvisors from a KJ Verada be plug and play in a Ralliart or is a lot of work needed? And would the lights fade out or was that a Verada option only?

There was no factory option for dual exhausts on the Ralliart. If I recall correctly, there may have been a group buy a few years ago with aftermarket Ralliart bumpers with dual cut-outs. But definitely not from the factory.

Not sure what lights the Ralliart have, but my TJ VR-X didn't come with any (although, thanks to mcs_xi, I now have footwell and ignition ring lights) and they all fade out.

None of what you're talking about is plug and play, you need to wire it all up yourself, the map lights will require the verada brackets and cutting the roof lining to size as well. If you can get a full roof loom its closer to plug and play, but it's fiddley changing the loom unless you pull the whole roof lining out (might even be the only way), and you'll need to tap in for the factory centre dome light if you want that to work too.

C piller light wiring is run to one side (passenger I believe), you'll need to extend it to the other. Whether or not they fade out depends on the BEM unit in your car, the veradas fade, most of the magna range doesn't, my lights don't fade out, they just turn off.

If you get one with the factory sunroof you will have the c pillar lights and the verada interior light

Doesn't matter, went and looked at a Ralliart in the state today, wasn't happy with it. Worn out would be the best way to put it, so will be passing. :(