Hey guys,

Looking to see if anybody knows the appropriate size silicon tube will fit over a 3rd Gen MAF sensor on the throttle body side?

Going to make a CAI to go from the skewed throttle body 6g75 intake manifold to MAF to pod.

Cheers!

wrap a piece of string around it and measure to get the perimeter
from this use pies, maths, and a calculator to work out the effective diameter of a circle with the same perimeter
this is, or is just over, the inner diameter of tubes required.

I pretty sure its 5" around the MAF sensor
Normally use a 3" to 5" silicone adaptor

Hmm might be 4.5"

3inch to 4inch,.... Use to make them back in the day, when you clamp them on the maf sencor it goes to the oval shape no worries... I Did a right up ON AMC a year or so ago