Hi just wondering can anyone tell me if two different types of drive shafts were used in TR/TS V6 Magnas? or will a driveshaft that fits a early V6 TR fit a late V6 TS? cheers

The manual for the TR-TS describes the different spline counts used on the various models/engines/gearboxes. CBF'd looking it up though. Maybe later . . . . . .

Oh, OK then . . . .

Spline sizes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
- 6 cyl. models . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 tooth spline
- 4 cyl. models 15" wheels . . . . . . . . . . . . . . . . . . . . . . 27 tooth spline
- 4 cyl. models 14" wheels . . . . . . . . . . . . . . . . . . . . . . 25 tooth spline
LH and RH shaft diameter
- 6 cyl. models ............................... .25.4 mm
- 4 cyl. models ............................... .24 mm
Drive shaft run out . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 .2 mm.
Transfer shaft
Diameter (ALL). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. 29 mm
Bearing type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Radial ball bearing

Section 26-2-1.

TR / TS V6 shafts should be the same as far as I can tell.

Thanks so much for your help Madmax, you info has been a big help, thank you


Section 26-2-1.

TR / TS V6 shafts should be the same as far as I can tell.

There is also a difference between Auto and Manual V6. I had this problem...