Ok so iv recently installed a new car stereo and installed a Bluetooth mic into the front drivers side pillar, but now it refuses to fit back into place properly. There are two small wedges at the bottom that have to sit in nicely but my front one won't even come close. Any suggestions?

http://i157.photobucket.com/albums/t70/bjtaylor_93/6AA111C3-6601-414F-A8A2-515179908008-8056-0000064BF3AD0DA9.jpg

http://i157.photobucket.com/albums/t70/bjtaylor_93/A9EF762F-DEDB-4DD2-83D6-8B3BCF8348AC-8056-0000064CA81C1C44.jpg

Ok so iv recently installed a new car stereo and installed a Bluetooth mic into the front drivers side pillar, but now it refuses to fit back into place properly. There are two small wedges at the bottom that have to sit in nicely but my front one won't even come close. Any suggestions?



Just persist, they can be a pain. Might be a bit easier to get them in if you pop the tweeter cover off next to it.

Just persist, they can be a pain. Might be a bit easier to get them in if you pop the tweeter cover off next to it.

Agreed, they can be a pain, just gotta persist until you get 'em to sit right. I've had mine off and on a few times now, tracking down elusive rattles.

Thanks guys,
finally got it in but had to pull the tweeter cover off like fooz recommended, as well as pull the vent on that side out lol.
i think someone had it out before me and didn't return it right, and it warped in the sun a bit. didnt realise the stock Bluetooth mic is there under the tweeter cover...
interesting.
thanks again guys.

They are very diddly

That is the best location, the parrot setup is one of the est out there