Anyone fitted the second generation EFI plenum to a first gen or can people confirm it definately will or will not fit as can get a second gen EFI setup cheap and contemplating a change when i do my balance shaft elimination in the next few weeks. Cheera thanks in advance Vee

appreantly it wont, the 2 are verry diferent lot taller and a little wider, ilet me know if u have luck because ive been thinking of doing it to mine

i will double check this wk when i go down the workshop if the manifold bolts on early heads. i have a full ts motor in a tp bit a a hassle as it rubs on the brake line which needs to be moved and the tps needs to be rewired.have not got my isc motor hooked up either the throttle bodys are 65mm as oppossed to 55mm i think.

i will double check this wk when i go down the workshop if the manifold bolts on early heads. i have a full ts motor in a tp bit a a hassle as it rubs on the brake line which needs to be moved and the tps needs to be rewired.have not got my isc motor hooked up either the throttle bodys are 65mm as oppossed to 55mm i think.

Any joy?? cheers
Ps is there a noticeable power increase with the Ts motor in the lighter Tp?

they do fit not worth the effort in a road car, litle more torque felt i only did it because got 2nd hand low km reco unit given to me thought it would be easier fit than it was

Will the top half of the Tr/Ts bolt to the bottom of the Tp as look very similar at the mid join the manifolds do?? Vee

both gaskets are diferent but could be posible with an adaptor block

but could be posible with an adaptor block

ooh la la that sounds like a possible way of doing it then!! Will have a closer look into it now!! Cheers .......Now to get a ts Plenum!!

i did have a fiber renforced plastic adaptor to fit a tr throttle on my tn pendlum worked well but not as eficant as modifing it for 70mm throttles