Hello. Just wondering if someone can tell me how you go about replacing a alternator belt on a 94 ts magna sedan 2.6. Just had a very quick look am i right in thinking you have to remove the crankshaft pulley as the alternator belt is behind another belt. Any tips would be very much appreciated.

Thanks in advance

Andy

method
http://www.aussiemagna.com/forums/showthread.php?p=855717#poststop

fitting the alternator and airconditioning belts

passengerside near the distributor

you have to slacken off the through bolt of the idler pully tensioner through nut-- a 14 mm eneough for the
the longer adjuster bolt to slacken off the for the tensioner to move down so you can get eneough slack to remove the belt


then moving to the front of the car undo the 14 mm lower secururing bolt of the adjuter a 14 mm - 3
slacken off a few turns of the through bolt holding the alternator to the block - 2
then unscrew the longer threaded bolt to take the tension of the alternator and powersteering belt -1

fitting both belts is harder start at the crank pully and fit and retighten
the alternator adjuster nut

then with a bit of pressure make the air conditioning belt fit back onto the idler pully and compressor ( a large scewdrive helps because there is not much room between the chassis and the engine retighten tensioner

go not over tighten the belts because they can snap
make sure the is some minimal deflection /slack on both belts]

ok many thanks for the info.