Hi all new to the club,i have just bought a 2007 GT but the memory seat buttons don't work.
I have checked the fuses and loom connections all seems fine although im not exactly sure of relay locations, all of the seat controls work just cant get memory to work (no green light). I'm hoping you guys may have some ideas, thanks in advance.

have you actually programmed in a position...?

When you have,press and hold the relevant button till you hear two beeps...position is now set.

Hi thanks for the reply, yes i have tried but the seat wont program no beeps and no lights.

Check the switch, I had one of these seats apart not long ago. The plug for the memory switch can pop out as it is quite small.

Take the side trim off and have a look.

Mike

In addition to Mike's post you can only use the memory function under certain conditions, to avoid accidental operation while driving. Memory function can be used with the car off and key set to ACC.

Sorry, didn't think of that one.

My seat was outside of a car, and I had it connected to work at anytime. I also think the shifter needs to be in park or N

& the drivers door open

& the drivers door open

Rubbish

Rubbish

Whats the door switch input do then?

Just get a new drivers seat they are not expensive.

Thanks everyone for your input, have tried all suggestions but it still doesn't work.
Oh well i'll get over it, thanks again.