was changing the water tempreture sender sensor today the little one at the back it snaped off flush been trying to get it out with a easy out but its copper so its just starting to break up
what the hell should i do ? this sucks

I'd drill it out as big as you can without damaging the housing thread and using a tiny punch or something similar and a small hammer tap out the remaining brass left in the housing and then you'll have to remove both the inlet and thermostat housings andtry to flush out any deposits in there before they get into the engine , but , im not mechanic, so im not telling you thats how it should be done, thats what i'd do

should i get a mechanic to get the rest out ?
if i **** the thread up ill be up shit creek without a paddle
how much would it cost?

should i get a mechanic to get the rest out ?
if i **** the thread up ill be up shit creek without a paddle
how much would it cost?
If your not confident in doing it yourself, yes , get a mechanic to fix her up, cost depends on how long they take to do it I guess