Hey guys,

I'm getting the 380 brake conversion and am looking at the OX 631 black/machined lip rim. i believe the magna PCD is 114.3? i'm just wondering if these rims would fit over 380 brakes? The rim is 18" x 7.5" and have an offset of either 40 or 45?

Cheers

We have the same wheels on our 380 in the 17inch with a 40 offset and have no problems with them at all so i can see no problem with them fitting

That should be fine mate =)

Beautiful! Thanks heaps

If you can choose which of the two offsets, 40 will look better than 45.

Will fill the guards better.

Anything over 16" will fit.

Anything over 16" will fit.

that's what i thought, until mal tried to put my rims back on yesterday....which are an 18"

the offset on your 18s must have been shocking. Any decently fitted rims should clear easily

I believe the offset of them was +35

I believe the offset of them was +35

They should fit with that offset fine, must be a weird rim design or something.

Do you need a spare set for a few days mate? Got only a couple of spare sets....

They should fit with that offset fine, must be a weird rim design or something.

They're the RJR linear wheels, ive seen a couple of them on here before. They cut off quite sharply at the top so that's probably why.



Do you need a spare set for a few days mate? Got only a couple of spare sets....

Thanks sean, but all good, Mal said he can lend me some for a few days. But very much appreciated!

Fyi they are the same that HULKSTAR is running on his VRX

Fyi they are the same that HULKSTAR is running on his VRX

I'm assuming he wouldn't have the 380 conversion then. U could put a spacer on the front and they would fit, but that is illegal and dangerous

These have a big lip on them thus I think the issue is not so much offset but the curve of the spokes, they dont hit by much, 2mm at best but is still too much to use them